Engineering, 31.10.2019 00:31 b2cutie456

On january 9, 2014, 10,000 gallons of crude mchm (75% pure, density=0.9074 g/cm3) was spilled into the elk river in wv, which is tributary to the ohio river (assume the spill occurred instantaneously). estimate the mchm concentration profile at the greater cincinnati water works intake 310 km downriver. the river had a flow of q=3,350 m3/s during the spill, the average river width is 400 m, average depth is 14 m, the average slope is 8x10-5 m/m and a rectangular cross section can be assumed. assume mchm is conservative (not reactive) in this environment. how does the mchm concentration profile you calculate compare to the actual concentration of about 20?

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

Answer

You know the right answer?

On january 9, 2014, 10,000 gallons of crude mchm (75% pure, density=0.9074 g/cm3) was spilled into t...

Questions