subject
Engineering, 30.10.2019 20:31 ghollins

Assume an mxn register file where m is the number of registers and n is the number of bits in each register. the register file can read 2 registers and optionally write a single register in each clock cycle on a clock edge if write is enabled. this results in 2 data outputs and 6 inputs. what are the different input and outputs of the register file?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 14:10
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
question
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
question
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
question
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
You know the right answer?
Assume an mxn register file where m is the number of registers and n is the number of bits in each r...
Questions
question
Social Studies, 03.12.2021 21:00
question
Computers and Technology, 03.12.2021 21:00
question
Health, 03.12.2021 21:00
Questions on the website: 13722367