Engineering, 29.10.2019 06:31 Kategaldamez3

Consider the propeller-driven general aviation aircraft in steady level longitudinal flight with a constant lift coefficient of 0.95.

a) what is the range of the aircraft in flight at an altitude of 2,000 ft? what are the initial airspeed, elevator deflection, and throttle setting with a full fuel tank? what are the terminal airspeed, elevator deflection, and throttle setting when the fuel tank is empty?

for a propeller-driven general aviation aircraft, wing surface area is 175ft^2. weight of the aircraft with a full tank is 2,900lbs. weight of the aircraft with an empty tank is 2,530lbs. the power specific fuel consumption rate is 0.45lb fuel/hr/hp. the air density at an altitude of 2000ft is 2.2409x10^-3 slug/ft^3. k=0.054. cd=0.026.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Avolume of 2.65 m3 of air in a rigid, insulated container fitted with a paddle wheel is initially at 264 k, 5.6 bar. the air receives 432 kj by work from the paddle wheel. assuming the ideal gas model with cv = 0.71 kj/kg • k, determine for the air the amount of entropy produced, in kj/k

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?

Answers: 3

Answer

You know the right answer?

Consider the propeller-driven general aviation aircraft in steady level longitudinal flight with a c...

Questions