Alead–tin alloy of composition 30 wt% sn–70 wt% pb is slowly heated from a temperature of 150°c (300°f).
(a) at what temperature does the first liquid phase form?
(b) what is the composition of this liquid phase?
(c) at what temperature does complete melting of the alloy occur?
(d) what is the composition of the last solid remaining prior to complete melting?

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false