subject
Engineering, 25.10.2019 19:43 skywil8981

Change shellcode. c as follows. what offset from the address of variable ret should be used here? in your report, explain how you use the assembly code to find out the layout of the variables in the program stack. assembly code can be obtained by using gdb disas command or gcc –s flag. also draw the program stack to analyze why the offset works. show the value of $esp and $ebp and the return address of main. compare the contents of the return address of main when entering and exiting main. print the address of variable shellcode and compare it with the contents of the return address of main.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
question
Engineering, 04.07.2019 18:20
Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process
Answers: 1
question
Engineering, 04.07.2019 19:20
Air enters a horizontal, constant-diameter heating duct operating at steady state at 290 k, 1 bar, with a volumetric flow rate of 0.25 m°/s, and exits at 325 k, 0.95 bar. the flow area is 0.04 m2. assuming the ideal gas model with k = 1.4 for the air, determine (a) the velocity at the inlet and exit, each in m/s, and (c) the rate of heat transfer, in kw flow rate, in kg/s, (b) the mass kg 0.3
Answers: 2
You know the right answer?
Change shellcode. c as follows. what offset from the address of variable ret should be used here? i...
Questions
question
Mathematics, 04.10.2020 19:01
question
Spanish, 04.10.2020 19:01
question
Mathematics, 04.10.2020 19:01
question
Computers and Technology, 04.10.2020 19:01
question
Mathematics, 04.10.2020 19:01
question
Mathematics, 04.10.2020 19:01
Questions on the website: 13722367