Engineering, 25.10.2019 04:43 kyllow5644

The ieee campus society office sells sodas for 35 cents. suppose they install a soda controller that only takes the following three inputs: nickel, dime, and quarter. after you put in each poin, you push a pushbutton to register the coin. if at least 35 cents has been put in the controller, it will output a soda and proper change (if applicable). draw a finite state machine that describes the behavior of the soda controller. each state will represent how much money has been put in (hint'. there will be seven of these states). once enough money has been put in, the controller will go to a final state where the person will receive a soda and proper change (hint: there are five such final states). from the final state, the next coin that is put in will start the process again.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

Answer

You know the right answer?

The ieee campus society office sells sodas for 35 cents. suppose they install a soda controller that...

Questions