subject
Engineering, 24.10.2019 18:43 desi0322

The power supplies in 1206 mudd feature an internal protection mechanism that limits the output current to 1 ampere. ideally, the protection circuit engages instantaneously when an over-current fault is detected, then disengages instantaneously once the fault condition is removed. while in the current limited state, the supply acts like an ideal current source. now suppose you set a supply to 5v then connect a fully discharged ideal 500mf (huge! ) capacitor to the the output. the supply will immediately go into current-limit. (a) why?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
question
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
question
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
question
Engineering, 04.07.2019 18:20
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
You know the right answer?
The power supplies in 1206 mudd feature an internal protection mechanism that limits the output curr...
Questions
Questions on the website: 13722363