Engineering, 23.10.2019 00:00 brittanyelliott028
The pressure and temperature at the beginning of compression of an air-standard diesel cycle are 95 kpa and 300 k, respectively. at the end of the heat addition, the pressure is 7.2 mpa and the temperature is 2150 k. determine (a) the compression ratio. (b) the cutoff ratio. (c) the thermal efficiency of the cycle. (d) the mean effective pressure, in kpa.
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
You know the right answer?
The pressure and temperature at the beginning of compression of an air-standard diesel cycle are 95...
Questions
Mathematics, 22.05.2020 07:00
English, 22.05.2020 07:00
Mathematics, 22.05.2020 07:00
Mathematics, 22.05.2020 07:00
Business, 22.05.2020 07:00
