Engineering, 20.10.2019 19:10 sirdre1982

Asteam power plant operates on a reheat rankine cycle. steam enters the high-pressure turbine at 12.5 mpa and 550 oc at a rate of 7.7 kg/s and leaves at 2 mpa. steam is then reheated at constant pressure to 450 oc before it expands in the low-pressure turbine.
the isentropic efficiency of the turbine and the pump are 85 % and 90 %, respectively. steam leaves the condenser as a saturated liquid. if the moisture content of the steam at the exit of the turbine is not to exceed 5 percent, determine (a) the condenser pressure, (b) the net power output, and (c) the thermal efficiency

need answers asap.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:10

How to increase the thermal officiency of an ideal simple rankino cycle? among these methods, which one is the best and why?

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?

Answers: 2

Answer

Engineering, 04.07.2019 19:20

To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.

Answers: 1

Answer

Engineering, 06.07.2019 02:30

Around steel bar, made from material with a yield stress of 750mpa, is loaded so that it has stresses co locations of maximum normal stress and maximum shear stress. use maximum shear stress and maximum distortion energy theories to calculate the safety factors for initial yielding failures.

Answers: 3

Answer

You know the right answer?

Asteam power plant operates on a reheat rankine cycle. steam enters the high-pressure turbine at 12....

Questions