Engineering, 19.10.2019 00:30 rina62

Suppose that the five measured samplertt values (see section 3.5.3) are 106 ms, 120 ms, 140 ms, 90 ms, and 115 ms. compute the estimatedrtt after each of these samplertt values is obtained, using a value of alpha= 0.125 and assuming that the value of estimatedrtt was 100 ms just before the first of these five samples were obtained. compute also the devrtt after each sample is obtained, assuming a value of beta= 0.25 and assuming the value of devrtt was 5 ms just before the first of these five samples was obtained. compute the tcp timeoutinterval after each of these samples is obtained.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

Answer

You know the right answer?

Suppose that the five measured samplertt values (see section 3.5.3) are 106 ms, 120 ms, 140 ms, 90 m...

Questions