Engineering, 18.10.2019 22:10 xelynncaldera
Annealing is a process by which steel is reheated and then cooled to make it less brittle. consider the reheat stage for a 100 mm thick plate (r = 7830 kg/m3, cp = 550 j/kg k, k = 48 w/m k). the plate initially is at 200 oc and is to be heated to a minimum temperature of 550 oc. heating is effected in a gas-fired furnace where the products of combustion at t[infinity] = 800 oc maintain a convection heat transfer coefficient of h = 250 w/m k on both surfaces of the plate.
(a) calculate the biot number for this heat transfer process.
(b) can the lumped-capacitance approximation be used to analyze this transient heat transfer process?
(c) assuming that the lowest temperature in the plate is at its midplane, calculate the dimensionless temperature at the midplane of the plate when temperature is 550 oc
(d) using the one-term approximate solution for convective heat transfer into a semi-infinite medium, calculate the fourier number required to achieve a temperature of 550 oc in the steel
(e) calculate the time required to achieve a temperature of 550 oc at the midplane of the plate.
Answers: 1
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Annealing is a process by which steel is reheated and then cooled to make it less brittle. consider...
Mathematics, 12.11.2019 20:31
History, 12.11.2019 20:31
Mathematics, 12.11.2019 20:31
Mathematics, 12.11.2019 20:31
History, 12.11.2019 20:31
Social Studies, 12.11.2019 20:31
Computers and Technology, 12.11.2019 20:31