Engineering, 15.10.2019 23:10 alexabessin

Compact fluorescent bulbs are much more efficient at producing light than are ordinary incandescent bulbs. they initially cost much more, but they last far longer and use much less electricity. according to one study of these bulbs, a compact bulb that produces as much light as a 100 w incandescent bulb uses only 23 w of power. the compact bulb lasts 10,000 hours, on the average, and costs $11.00, whereas the incandescent bulb costs only $0.75, but lasts just 750 hours. the study assumed that electricity costs $0.080 per kilowatt-hour and that the bulbs are on for 4.0 h per day. (a) what is the total cost (including the price of the bulbs) to run each bulb for 3.0 years? (b) how much do you save over 3.0 years if you use a compact fluorescent bulb instead of an incandescent bulb? (c) what is the resistance of a "100 w" fluorescent bulb? (remember, it actually uses only 23 w of power and operates across 120 v.)

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.

Answers: 1

Answer

Engineering, 06.07.2019 02:30

Around steel bar, made from material with a yield stress of 750mpa, is loaded so that it has stresses co locations of maximum normal stress and maximum shear stress. use maximum shear stress and maximum distortion energy theories to calculate the safety factors for initial yielding failures.

Answers: 3

Answer

You know the right answer?

Compact fluorescent bulbs are much more efficient at producing light than are ordinary incandescent...

Questions