Engineering, 15.10.2019 22:30 witchhunt666

A. given the following equation for a general ac waveform, label v , ω, and φ. a = v cos (ωt + φ) b. start the waveforms 2015 software. you do not need the ad2 to be plugged in. using the demo discovery 2, simulate various waveforms using the wavegen tool. refer to appendix c for further details on how to use waveforms 2015. make a comment (1-2 sentences) on what happens to the waveform as you adjust the amplitude. make a comment (1-2 sentences) on what happens to the waveform as you adjust the frequency. make a comment (1-2 sentences) on what happens to the waveform as you adjust the phase shift. c. simulate three signals of varying amplitudes and phase shifts. maintain the frequency at 30 hz. d. express your three signals in both polar and rectangular form. e. plot the rectangular form of the equation on the complex plane.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

Answer

You know the right answer?

A. given the following equation for a general ac waveform, label v , ω, and φ. a = v cos (ωt + φ) b....

Questions