Engineering, 15.10.2019 05:00 cmaya
A5/8-in.-diameter steel rod ab is fitted to a round hole near end c of the wooden member cd. the ultimate strength of the wood used is 8 ksi in tension and 1 ksi in shear, while the ultimate shear strength of the steel is 22 ksi. determine (a) the factor of safety for the pin, (b) the average bearing stress in the wood, (c) the required value of b if the factor of safety for the wooden member in shear is 3.0, (d) the maximum average normal stress in the wood.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
Engineering, 04.07.2019 19:10
Which of the following is the most important advantage of a large field of view? a. allows larger areas to be examined b. relieves eyestrain c. minimizes parallax errors. d. increases precision in proportion to the in- crease in field of view
Answers: 2
You know the right answer?
A5/8-in.-diameter steel rod ab is fitted to a round hole near end c of the wooden member cd. the ult...
Questions
Spanish, 09.02.2021 16:00
Mathematics, 09.02.2021 16:00
Mathematics, 09.02.2021 16:00
Advanced Placement (AP), 09.02.2021 16:00
English, 09.02.2021 16:00
Mathematics, 09.02.2021 16:00
Mathematics, 09.02.2021 16:00
