Engineering, 15.10.2019 05:00 coreycbg1127

Adrillstring is composed of 9000 ft of 5-in. 19.5-lbm/ft drillpipe and 1000 ft of drill collars having a 8.0-in. od, 3.0-in. id. compute: a) capacity of the drillpipe in barrels. b) capacity of the drill collars in barrels. c) number of pump cycles required to pump surface mud to the bit. the pump is a duplex double acting pump with 6-in. liners, 2.5-in. rods, 16-in. strokes, and operates at a volumetric efficiency of 85%. d) displacement of the drillpipe in bbl/ft. e) displacement of the drill collars in bbl/ft. the od of the collars is 8.0-in

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

Answer

Engineering, 04.07.2019 18:20

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

Answer

Engineering, 04.07.2019 18:20

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.

Answers: 2

Answer

You know the right answer?

Adrillstring is composed of 9000 ft of 5-in. 19.5-lbm/ft drillpipe and 1000 ft of drill collars havi...

Questions