The company flew an aircraft to mobile alabama for maintenance, repair, and overhaul (mro) service. the aircraft basic weight was 2886 and had a moment calculated at 101673.78. while in the hanger the aircraft was required to be modified. two 15 pound seats located at station +71 were required to be removed. a new cabinet weighing 97 pounds was installed in place of the seats (at station +71). also at station +71, an upgraded seat weighing 20 pounds was installed. as part of the new modification, new radio equipment was installed at station +94 weighing 30 pounds. calculate the new weight of the aircraft and cg of the aircraft after modification:

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater