Engineering, 09.10.2019 04:10 zistoe0430

To increase fault-tolerance, the security administrator for corp has installed an active/passive firewall cluster where the second firewall is held in reserve in case of primary firewall failure. stateful firewall inspection is being used in the firewall implementation. there have been numerous reports of dropped connections with external clients. which of the following is most likely the cause of this problem?

(a) all packets are traversing the passive firewall causing the connections to be dropped.
(b) the heartbeat between the firewalls is not enabled.
(c) inbound packets are traversing the active firewall and return traffic is being sent through the passive firewall.
(d) all packets are traversing the active firewall causing the connections to be dropped.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?

Answers: 3

Answer

You know the right answer?

To increase fault-tolerance, the security administrator for corp has installed an active/passive fir...

Questions