Engineering, 07.10.2019 22:20 maddigrace3

Need asap
1. what material is specified?

2. what tolerances are allowed on:

(a) decimal dimensions?

(b) fractional dimensions?

(c) angular dimensions?

3. what heat-treating process is required after rough machining?

4. determine overall basic dimensions a b c.

5. what is the radius of all fillets and rounds?

6. compute dimensions d and e .

7. how many holes are .500?

8. how many external threads are to be cut?

9. what thread series is used for the internal and external threads?

10. what does 3/4 - 16unf - 2a - lh mean?

11. what are the upper- and lower-limits of the .7500 diameter portion?

12. what does 1 1/2 - 16un - 3a - lh mean?

13. what does .312 - 18unc - 1b mean?

14. what is the lower-limit diameter of the unthreaded 1 1/20 diameter portion?

15. determine the length of the 1 1/20 - 16 threaded portion.

16. how many holes are to be threaded 10 - 32unf?

17. how deep are the holes to be threaded?

18. give the angle to the horizontal at which the 10 - 32unf holes are to be drilled.

19. give the diameter of the circle on which the 10 - 32unf tapped holes are located.

20. identify the system of dimensioning used on the drawing of the rocker base.

21. change the decimal and angular tolerances so they apply in one direction (1) only. then, determine the upper- and lower-limit dimensions for a , b , c , d , e , and the 45° angle.

Need asap1. what material is specified? 2. what tolerances are allowed on:

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options

Answers: 2

Answer

You know the right answer?

Need asap
1. what material is specified?

2. what tolerances are allowed on:
...

Questions