Engineering, 07.10.2019 19:30 jcotto3644

We as humans write math expression in infix notation, e. g. 5 + 2 (the operators are written inbetween the operands). in computer’s language, however, it is preferred to have the operators on the right side of the operands, i. e. 5 2 +. for more complex expressions that include parenthesis and multiple operators, a compiler has to convert the expression into postfix first and then evaluate the resulting postfix. write a program that takes an "infix" expression as input, uses stacks to convert it into postfix expression, and finally evaluates it. it must support the following operations: + - / * ^ % (exampleinfix expression: (7 - 3) / (2 + 2)postfix expression: 7 3 - 2 2 + /result: 1

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point.the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

You know the right answer?

We as humans write math expression in infix notation, e. g. 5 + 2 (the operators are written inbetwe...

Questions