Engineering, 06.10.2019 08:00 vkrizh

A1045 hot-rolled steel tension test specimen has a diameter of 5.75 mm and a gage length of 29 mm. in a test to fracture, the stress and strain data below were obtained. determine(a) the modulus of elasticity.(b) the proportional limit.(c) the ultimate strength.(d) the yield strength (0.05% ) the yield strength (0.20% ) the fracture stress.(g) the true fracture stress if the final diameter of the specimen at the location of the fracture was 4.28 mm. load change in length load change in length(kn) (mm) (kn) (mm)0.00 0.00 10.34 0.292.33 0.01 12.14 0.614.66 0.02 14.18 1.046.98 0.03 16.67 1.809.31 0.04 17.49 2.269.67 0.05 17.80 2.789.96 0.06 17.37 2.7810.28 0.08 16.42 3.8310.34 0.09 16.12 3.9410.34 0.10 15.94 4.0010.34 0.14 15.76 4.0610.34 0.17 15.56 4.12 15.43 fracture

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 03.07.2019 19:30

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

You know the right answer?

A1045 hot-rolled steel tension test specimen has a diameter of 5.75 mm and a gage length of 29 mm. i...

Questions