Engineering, 06.10.2019 01:00 paytonthalacker

An important property of an engineering requirement that we saw earlier was verifiability. veriﬁability seeks to answer the question of whether or not the system is being developed cor- rectly, or "are we building the product correctly? " a related concept is that of validation, which seeks to answer the question "are we building the correct product? " more formally, validation is the process of determining whether the system meets the needs of the user—is it valid? this is more general in scope than veriﬁcation and more difﬁcult to show. require- ments validation is usually carried out by reviews of the requirements by a team of people. validation is demonstrated by being able to answer the following questions in the afﬁrmative

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

The proportional limit is always greater than the yield strength for a material. a)-trune b)- false

Answers: 3

Answer

Engineering, 05.07.2019 23:20

Which one of the following faults cause the coffee in a brewer to keep boiling after the brewing cycle is finished? a. an open circuit in the heating element b. a short circuit at the terminals c. welded contacts on the thermostat d. a leak around the gasket

Answers: 3

Answer

Engineering, 06.07.2019 03:10

Oxygen at 300 kpa and 400 k is in a closed system with an initial volume of 0.1 m3. is now compressed in a polytropic process, with exponent of n 1.2, to a temperature of 500 k. calculate: a) the boundary work done during the compression, in kj b) the heat transfer during the compression, in kj

Answers: 3

Answer

You know the right answer?

An important property of an engineering requirement that we saw earlier was verifiability. veriﬁabil...

Questions