subject
Engineering, 05.10.2019 13:00 valerrry

Acetone flows at a volume flow rate of 50 gpm through a 2 nominal schedule 40 commercial steel pipe. the pipe is laid out horizontally and is 50 ft long. calculate the pressure drop.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
question
Engineering, 06.07.2019 02:30
A75mm diameter shaft is supported in a journal bearing 75mm long with a diametral clearance of 0. 1mm. it supports a radial load of 1000 n and is lubricated with sae 50 oil at 70°c. find the friction torque and the power loss when the crankshaft rotates at 2900 rev/min.
Answers: 1
question
Engineering, 06.07.2019 03:10
An electrical kettle is made out of stainless steel,weighs two pounds (when empty) with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling.
Answers: 1
question
Engineering, 06.07.2019 05:10
Asteam turbine is supplied with steam at 28bar and 425c. a fraction of the steam is extracted at 1.2bar to heat the feed water in one open feed water heater. the rest of the steam expands in the low pressure stage of the turbine to 0.08bar. a)-sketch the regenerative rankine cycle with open feed water heater on the t-s diagram. b)-assuming isentropic expansion in both stages of the turbine, find the cycle efficiency. do not assume negligible pump work.
Answers: 1
You know the right answer?
Acetone flows at a volume flow rate of 50 gpm through a 2 nominal schedule 40 commercial steel pipe....
Questions
question
English, 15.11.2019 00:31
Questions on the website: 13722363