Engineering, 28.09.2019 00:10 orgaprince
An intercooler is installed between stages of a two-stage air compressor to reduce compressed air’s temperature (see the figure below). the compressed air flows through the intercooler whose inner and outer diameter are 5 and 6 cm, respectively. to simplify the solution, the outer walls are assumed to be at a temperature of 185 oc. to increase the heat transfer for the intercooler, circular aluminium alloy 2024-t6 fins (k=186 w/m. k) of outer diameter 15 cm and constant thickness 1 mm are attached to the intercooler. the space between the fins is 1 mm, and there are 15 fins per meter length of the intercooler. heat is transferred to the surrounding air at t[infinity] = 25 oc, with a convection heat transfer coefficient of 40 w/m2.k. (i) determine the heat transfer from the intercooler for its total length with no fins added.(ii) determine the heat transfer from the intercooler for its total length as a result of the fins added. (iii) determine the percentage increase in heat transfer from the intercooler for its total length as a result of the fins added. also, comment on the value. (iv) determine the overall and individual fin effectiveness
Answers: 1
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 19:10
What are the major differences between injection molding and extrusion?
Answers: 2
Engineering, 04.07.2019 19:10
Starting wih an energy balance on a rectangular volume element, derive the one- dimensional transient heat conduction equation for a plane wall with constant thermal conductivity and no heat generation.
Answers: 1
An intercooler is installed between stages of a two-stage air compressor to reduce compressed air’s...
Medicine, 04.03.2022 02:00
World Languages, 04.03.2022 02:00
World Languages, 04.03.2022 02:00
Business, 04.03.2022 02:00
Mathematics, 04.03.2022 02:00
Mathematics, 04.03.2022 02:00
Health, 04.03.2022 02:00
World Languages, 04.03.2022 02:00
Mathematics, 04.03.2022 02:00
Social Studies, 04.03.2022 02:00
Mathematics, 04.03.2022 02:10