Engineering, 20.09.2019 01:30 wendybhenry61391
Assume a particular function in a 65nm process being used today requires a die area of 0.5cm2 and that it is fabricated on 300mm wafers that cost $3200. predictions now suggest that in a few years, high-end processes will have 7nm feature sizes on 450mm wafers. if the 450mm wafers cost $1 each, what will be the approximate cost per good die of the same function if fabricated in the new high-end process with feature sizes of 7nm?
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables
Answers: 1
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Engineering, 04.07.2019 18:20
Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t
Answers: 3
You know the right answer?
Assume a particular function in a 65nm process being used today requires a die area of 0.5cm2 and th...
Questions
Advanced Placement (AP), 29.06.2019 09:30
History, 29.06.2019 09:30
Mathematics, 29.06.2019 09:30
Mathematics, 29.06.2019 09:30
History, 29.06.2019 09:30
Mathematics, 29.06.2019 09:30
