Engineering, 18.09.2019 00:20 Chantamariepaul

Rigid bar abc is supported by a pin at bracket a and by tie rod (1). tie rod (1) has a diameter of 7 mm, and it is supported by double-shear pin connections at b and d. the pin at bracket a is a single-shear connection. the pin at b is 8 mm in diameter. assume a = 540 mm, b = 270 mm, h = 340 mm, and θ= 55°. if the normal stress in tie rod (1) cannot exceed 180 mpa and the shear stress in pin b cannot exceed 130 mpa, determine the maximum load pmax that can be supported by the structure.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?

Answers: 3

Answer

You know the right answer?

Rigid bar abc is supported by a pin at bracket a and by tie rod (1). tie rod (1) has a diameter of 7...

Questions