Engineering, 14.09.2019 04:30 sugakookies1

The cooling coil of an air - conditioning system is a heat exchanger in which air passes over tubes through which refrigerant 22 flows. air enters with a volumetric flow rate of 40 m3/min at 27degreec, 1.1 bar. and exits at 15degreec. 1 bar. refrigerant enters the tubes at 7 bar with a quality of 16% and exits at 7 bar, 15degreec. ignoring heat transfer from the outside of the heat exchanger and neglecting kinetic and potential energy effects, determine at steady state the mass flow rate of refrigerant, in kg/min. the rate of energy transfer, in kj/min. from the air to the refrigerant.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 03:10

What precautions should you take to prevent injuries when dealing with heavy loads?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

You know the right answer?

The cooling coil of an air - conditioning system is a heat exchanger in which air passes over tubes...

Questions