Engineering, 14.09.2019 02:20 Dweath50
Asteady mass flow rate (m1) of superheated steam flows through a turbine used in a power plant to drive an electric generator. the superheated steam enters the adiabatic turbine at a pressure of p1 and a temperature of t1. the steam expands in the turbine until it exits at a pressure of p2. the turbine has an isentropic efficiency of n . determine the following given the properties listed below. given values m1 (kg/s) = 45 p1 (mpa) = 14 t1 (c) = 464 p2 (bar) = 0.7 n (%) = 83. determine the specific actual specific enthalpy (kj/kg) at the turbine exit. determine the power output (mw) of the turbine
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:20
Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms
Answers: 2
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
Engineering, 06.07.2019 02:30
A75mm diameter shaft is supported in a journal bearing 75mm long with a diametral clearance of 0. 1mm. it supports a radial load of 1000 n and is lubricated with sae 50 oil at 70°c. find the friction torque and the power loss when the crankshaft rotates at 2900 rev/min.
Answers: 1
Engineering, 06.07.2019 04:10
Steam enters a converging nozzle at 3.0 mpa and 500°c with a negligible velocity, and it exits at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: is isentropic (a) (b) has an efficiency of 94 percent
Answers: 1
You know the right answer?
Asteady mass flow rate (m1) of superheated steam flows through a turbine used in a power plant to dr...
Questions
History, 11.12.2019 22:31
Chemistry, 11.12.2019 22:31
Social Studies, 11.12.2019 22:31
