Engineering, 14.09.2019 01:30 pierceybbpow8o39

I) explain what is meant by continuity of flow. ii) oil flows through a pipe of internal diameter 100mm at a velocity of 8 m/s. the pipe then splits into two branches. one branch has an internal diameter of 75mm and the fluid is measured to be flowing with a velocity of 5 m/s. if the other branch has an internal diameter of 50mm, at what velocity will the oil flow through this section? b) i) state bernoullis equation and state which form of energy each term represents. ii) a fluid of density 950kg/m3 flows steadily through a tapered tube as shown below. at section 1 the pressure is 250kn/m2 , the velocity is 12 m/s and pipe diameter is 0.1m. if the pipe diameter at section 2 is 0.3m, find the velocity and pressure at section 2

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation

Answers: 1

Answer

You know the right answer?

I) explain what is meant by continuity of flow. ii) oil flows through a pipe of internal diameter 10...

Questions