Engineering, 14.09.2019 00:30 averiemiranda1
The pressure and temperature at the beginning of compression of a cold air-standard diesel cycle are 100 kpa and 300k, respectively. at the end of the heat addition, the pressure is 7.2 mpa and the temperature is 2250 k. assume constant specific heats evaluated at 300 k. determine the cut-off ratio. there is a +/- 5% tolerance.
Answers: 3
is the temperature at the end of compression process
Another question on Engineering
Engineering, 03.07.2019 14:10
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
Engineering, 04.07.2019 18:10
The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody
Answers: 2
Engineering, 04.07.2019 18:10
The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length
Answers: 2
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
You know the right answer?
The pressure and temperature at the beginning of compression of a cold air-standard diesel cycle are...
Questions
Mathematics, 21.06.2020 03:57
Mathematics, 21.06.2020 03:57
Mathematics, 21.06.2020 03:57
Mathematics, 21.06.2020 03:57
Mathematics, 21.06.2020 03:57
Mathematics, 21.06.2020 03:57
Mathematics, 21.06.2020 03:57
Mathematics, 21.06.2020 03:57
Mathematics, 21.06.2020 03:57
Health, 21.06.2020 03:57
Mathematics, 21.06.2020 03:57
