subject
Engineering, 13.09.2019 23:30 swaggg2084

The 30 degree vertical bend in a pipe with a 2 ft diameter
carries water (rho = 62.4 lbm/ft^3) at a rate of 31.4 cfs. if the
pressure p1 is 10 psi at the lower end of the bend, where the
elevation is 100 ft, and p2 is 8.5 psi at the upper end, where the
elevation is 103 ft, what will be the vertical component of force
that must be exerted by the "anchor" on the bend to hold it in
position? the bend itself weighs 300 lb, and the length l is 4
ft.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false
Answers: 1
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
question
Engineering, 04.07.2019 18:10
Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1
Answers: 1
You know the right answer?
The 30 degree vertical bend in a pipe with a 2 ft diameter
carries water (rho = 62.4 lbm/ft^3)...
Questions
question
Mathematics, 27.10.2021 01:00
question
Mathematics, 27.10.2021 01:00
Questions on the website: 13722360