subject
Engineering, 13.09.2019 23:30 budjasdatazaki467

Asteam power plant operates on an ideal regenerative rankine cycle with one open feedwater heater operating at 0.125 mpa. steam enters the first turbine stage at 15 mpa, 600 oc. condensate exiting the feedwater as saturated liquid at 0.125 mpa. the condenser pressure is 2.5 kpa. for isentropic processes in the two turbine stages and the pump, determine the followings: a) the net work of the cycle in kj/kg; b) the mass flow rate into the first-stage turbine, in kg-hr, if the net power developed for this power plant is 212 mw. c) the heat transfer into the working fluid through the boiler in kj/kg; d) the thermal efficiency of the cycle in %.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
question
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
question
Engineering, 04.07.2019 18:10
Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k
Answers: 2
question
Engineering, 04.07.2019 18:20
Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]
Answers: 1
You know the right answer?
Asteam power plant operates on an ideal regenerative rankine cycle with one open feedwater heater op...
Questions
Questions on the website: 13722363