subject
Engineering, 13.09.2019 23:10 u8p4

Cutting speed is determined by the surface velocity of the tool. a) true b) false

ansver
Answers: 2

Another question on Engineering

question
Engineering, 06.07.2019 03:10
Two slings are used to lift a girder of length l and uniform weight per unit length. what is the best position for the slings if the bending moment due to the weight of the girder is to be kept to a minimum?
Answers: 2
question
Engineering, 06.07.2019 03:10
Asolid steel sphere (k=63.9 w m-1 k-1 , ? =7832 kg m-3 , c=0.523 kj kg-1 k-1 ), 100 mm in diameter is initially at a uniform temperature of 500o c and is suddenly quenched in a large oil bath for which t? = 100o c and h = 3200 w m-2 k-1. estimate the time required for the sphere to cool to 200o c and to 110o c
Answers: 1
question
Engineering, 06.07.2019 05:10
The ivanpah solar thermal power plant cost $2.2 billion to build. the gross plant electric output is 392 mw, and the net output is 377 mw. the planned capacity factor was 27.4%, but the actual capacity factor in 2016 was 20.5%. at best the plant thermal efficiency appears to be 18%. in addition, for the daily startup process, the solar plant also burned 1.3x10^12 btu of natural gas in 2016. the cost of natural gas in 2016 was about $2.5 per million btu. assuming a levelized annual fixed charge rate of 7%, determine (a) the capital cost (c/kwh) and (b) the fuel cost (e/k wh) for the electricity in 2016.
Answers: 3
question
Engineering, 06.07.2019 05:10
Air undergoes a constant pressure cooling process with no moisture added or removed. the air originally exists at 45 °c, 150 kpa and 35 % relative humidity. it is cooled until the temperature reaches 29 oc. determine (a) the relative humidity of the cooled air. (b) the dew point temperature of the cooled air in °c. (c) the heat removed during the cooling process in kj/kg. use the psychrometric chart to check your answers (this part will not be graded; however, it will you get comfortable using the psychrometric chart)
Answers: 3
You know the right answer?
Cutting speed is determined by the surface velocity of the tool. a) true b) false...
Questions
question
Mathematics, 08.01.2020 23:31
Questions on the website: 13722362