subject
Engineering, 13.09.2019 22:30 davidb1113

Fermentation of starch and sugar crops yields 5% to 20% molar volume of ethanol in water, which is too wet to burn. distillation of this mixture to remove water produces a mixture of 95% ethanol and 5% water, the azeotrope of the mixture, which is called hydrous ethanol. detydration to anhydrous ethanol, which is 99.7% pure ethanol and is the standard for blending with gasoline in the u. s., requires additional processing and costs. in brazil most vehicles are flex fuel vehicles of a different design that flex fuel vehicles in the u. s., in that they can burn straight hydrous ethanol (no gasoline) as well as any mixtures of gasoline and hydrous ethanol 1a) calculate the enthalpy change when oxidizing (burning) pure ethanol in air if the initial temperature is at 25c and the exhaust temperatures is 6ook. 1b) recalculate the enthalpy change for a hydrous ethanol mixture of 95% ethanol and 5% water. assume the 95: 5 mixture of ethanol and water is on a mass basis.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
question
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
question
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
You know the right answer?
Fermentation of starch and sugar crops yields 5% to 20% molar volume of ethanol in water, which is t...
Questions
question
Social Studies, 05.09.2019 02:30
Questions on the website: 13722361