Engineering, 13.09.2019 22:20 deedivinya
What do we mean by tolerance and how is it determined while designing parts? what is the relation between tolerances and the manufacturing processes used?
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false
Answers: 2
Engineering, 04.07.2019 18:10
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
What do we mean by tolerance and how is it determined while designing parts? what is the relation b...
Questions
Advanced Placement (AP), 06.11.2020 21:50
Mathematics, 06.11.2020 21:50
Biology, 06.11.2020 21:50
Mathematics, 06.11.2020 21:50
Mathematics, 06.11.2020 21:50
History, 06.11.2020 21:50
Mathematics, 06.11.2020 21:50
Mathematics, 06.11.2020 21:50
Mathematics, 06.11.2020 21:50
Mathematics, 06.11.2020 21:50
Mathematics, 06.11.2020 21:50
