An aluminum bar 125mm (5in) long and having a square cross section 16.5mm (.65in) on an edge is pulled in tension with a load of 66,700 n (15000lb) and experiences an elongation of .43mm (1.7*10^-2 in ). assuming that the deformation is entirely elastic, calculate the modulus of elasticity of the aluminum.

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.