Engineering, 11.09.2019 02:20 Asterisk

Electrically heated draw batch furnaces are commonly used in the heat treatment industry. consider a draw batch furnace front made of a 20-mm thick steel plate with a thermal conductivity of 37 w/m·k. the furnace is situated in a room with surrounding air temperature of 20°c and an average convection heat transfer coefficient of 10 w/m2·k. if the inside surface of the furnace front is subjected to uniform heat flux of 5 kw/m2 and the outer surface has an emissivity of 0.30, determine the inside surface temperature of the furnace front in k. (round your answer up to 2 decimal places.) the stefan–boltzmann constant is 5.67 × 10-8 w/m2 . k4

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges

Answers: 1

Answer

You know the right answer?

Electrically heated draw batch furnaces are commonly used in the heat treatment industry. consider a...

Questions