Engineering, 11.09.2019 01:20 kobiemajak

The outlet structure on a pond is used to regulate the flow out of a pond for different storm events. an outlet structure must be designed to discharge 2.20 m^3/min when the water surface elevation in the pond reaches 1.52 m, and 6.29 m^3/min when the water surface elevation reaches 2.60 m. the outlet structure will be a circular oriface and a sharp crested rectangular weir combination, with the centroid of the oriface at an elevation of 0.90 m and the weir crest at an elevation of 2.50 m. both will discharge to free outfall conditions. assume an oriface coefficient of 0.6. find the oriface diameter needed to supply the correct discharge when the water surface reaches the first specified elevation. what will the discharge from the oriface be when the water surface reaches the second specified elevation? find the width of the weir needed to supply the extra discharge necessary to meet the requirement. use mannings formula when necessary.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Avolume of 2.65 m3 of air in a rigid, insulated container fitted with a paddle wheel is initially at 264 k, 5.6 bar. the air receives 432 kj by work from the paddle wheel. assuming the ideal gas model with cv = 0.71 kj/kg • k, determine for the air the amount of entropy produced, in kj/k

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?

Answers: 3

Answer

You know the right answer?

The outlet structure on a pond is used to regulate the flow out of a pond for different storm events...

Questions