subject
Engineering, 10.09.2019 18:30 elielson1497

The deepest part in the ocean is the challenger deep within the mariana trench, which has a maximum depth of around 11,000 m. this question will look to estimate the pressure at this depth in the ocean. (a) (2 points) assuming that the salt water in the ocean has a constant density of 1030 kg/m", compute the pressure at this deepest point in the ocean. use gage (relative) pressure, with p= 0 pa at the surface. (b) (4 points) while liquids are approximately incompressible, at such depths density variations can be noticeable. assume that the density of the water varies with depth by the equation p- po ppo cape p= po exp where po and po are the density and pressure at the surface, and ey = 2.3 x 10° n/m² is the modulus of elasticity of water. using the differential form of the hydrostatic pressure equation dp da = -29, determine the pressure at the deepest point of the challenger deep. as- sume that po = 1030 kg/m². how does this compare to your answer for part (a)?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
question
Engineering, 04.07.2019 18:20
Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options
Answers: 2
question
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
You know the right answer?
The deepest part in the ocean is the challenger deep within the mariana trench, which has a maximum...
Questions
question
Mathematics, 29.04.2021 04:50
question
Mathematics, 29.04.2021 04:50
question
Mathematics, 29.04.2021 04:50
question
Mathematics, 29.04.2021 04:50
question
Mathematics, 29.04.2021 04:50
question
Biology, 29.04.2021 04:50
Questions on the website: 13722363