Engineering, 10.09.2019 03:30 Brock2002

Afreezer compartment is covered with a 2-mm thick layer of frost at the time ii malfunctions. if the compartment is in ambient air at 20 degree c and a coefficient of h = 2 w/m2 k characterizes heat transfer by natural convection from the exposed surface of the layer, estimate the time required to completely melt the frost the frost may be assumed to have a mass density of 700 kg/m3 and a latent heat of fusion of 334 kj/kg.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

Answer

You know the right answer?

Afreezer compartment is covered with a 2-mm thick layer of frost at the time ii malfunctions. if the...

Questions