subject
Engineering, 03.09.2019 05:10 michelemosbahiow6yya

If an aluminum plate 4 mm thick is mounted in a horizontal position, and its bottom surface is well insulated. a special, thin coating is applied to the top surface such that it absorbs 80% of any incident solar radiation, while having an emissivity of 0.25. the density p and specific heat c of aluminum are known to be 2700 kg/m3 and 900 j/kg k, respectively. (a) consider conditions for which the plate is at a temperature of 25 c and its top surface is suddenly exposed to ambient air at t=20 c and to solar radiation that provides an incident flux of 900 w/m2 . the convection heat transfer coefficient between the surface and the air is h = 20 w/m^2 k. what is the initial rate of change of the plate temperature?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false
Answers: 3
question
Engineering, 04.07.2019 18:10
Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1
Answers: 1
question
Engineering, 04.07.2019 19:10
The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false
Answers: 2
question
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
You know the right answer?
If an aluminum plate 4 mm thick is mounted in a horizontal position, and its bottom surface is well...
Questions
Questions on the website: 13722367