Engineering, 31.08.2019 05:30 ismailhajisaid29101
You have a piece of 1045 steel 80 cm long and 30 cm wide and 15cm high. in this piece it is desired to make a groove along the 80 cm with a width of 8 cm with a depth of 10 cm. calculate the progress that the tool must have to make the groove in a time of 5 minutes. it assumes that for this operation an end mill flat tool of 4 mm diameter is used and its maximum axial cutting capacity is 50 mm.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
Engineering, 04.07.2019 18:20
Inadequate stores control is not an obstacle to effective work order system. (clo4) a)-true b)-false
Answers: 3
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
You know the right answer?
You have a piece of 1045 steel 80 cm long and 30 cm wide and 15cm high. in this piece it is desired...
Questions
Computers and Technology, 13.06.2021 02:00
Mathematics, 13.06.2021 02:00
Mathematics, 13.06.2021 02:00
Physics, 13.06.2021 02:00
Mathematics, 13.06.2021 02:00
Biology, 13.06.2021 02:00
Mathematics, 13.06.2021 02:00
