Engineering, 31.08.2019 05:30 cat20220

An operating theatre is maintained at an inside temperature of 26°c dry-bulb when the outside air is at 40°c dry-bulb, 22°c wet-bulb and the sensible and latent heat gains in the operating theatre are 9 kw and 3 kw, respectively. a 100 per cent fresh air is handled, the air temperature leaving the cooling coil being 14°c and the apparatus dewpoint 12°c. assume a rise of 1.5°c across the supply fan (which is located after the cooling coil) and a further rise of 2°c because of heat gains to the supply duct. show the psychrometric processes on the psychrometric chart and determine (a) the shf (sensible heat factor) in the theatre (b) the wet bulb temperature of the supply air just after the cooling coil (c) the relative humidity of the air maintained in the theatre. (d) mass flow rate of supply air required (e) the cooling load of the cooling coil

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 18:10

You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?

Answers: 1

Answer

You know the right answer?

An operating theatre is maintained at an inside temperature of 26°c dry-bulb when the outside air is...

Questions