Engineering, 30.08.2019 05:30 asmita9876
Acaliper brake is required for the front wheels of a passenger car with a braking capacity of 500 nm for each brake. preliminary design estimates have set the brake geometry as ri = 110 mm' and 0 = 43°. pads with a coefficient of friction of 0.38 have been selected. each pad is actuated by means of a hydraulic cylinder of nominal diameter 25.4 mm. determine: 3.1 the required actuating force, the average and the maximum contact pressures, the required hydraulic pressure for brake actuation
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 14:10
Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.
Answers: 1
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
You know the right answer?
Acaliper brake is required for the front wheels of a passenger car with a braking capacity of 500 nm...
Questions
Mathematics, 22.03.2021 01:00
Chemistry, 22.03.2021 01:00
SAT, 22.03.2021 01:00
Mathematics, 22.03.2021 01:00
Mathematics, 22.03.2021 01:00
Arts, 22.03.2021 01:00
Mathematics, 22.03.2021 01:00
