Engineering, 24.08.2019 04:30 Nweze1760

Asteam power plant operates on a simple real rankine cycle between the pressure limits of 20 mpa and 20 kpa in the boiler and condenser, respectively. due to the metallurgic limits in fabrication of the turbine blades, the maximum temperature in the cycle is not to exceed 600 °c. the isentropic efficiency is 75% for both the turbine and the pump. illustrate the cycle on a t-s diagram with respect to the saturation lines. calculate the rate of work done by the compressor on the steam flow. determine the rate of heat input and output in the boiler and condenser, respectively, when the power plant operates at its maximum capacity. what is the thermal efficiency of the cycle? determine the required mass flow rate of the steam through the cycle to generate 210 mw in the power plant.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

Answer

You know the right answer?

Asteam power plant operates on a simple real rankine cycle between the pressure limits of 20 mpa and...

Questions