Engineering, 23.08.2019 16:10 1kafran1

Asteam power plant operates on a simple nonideal rankine cycle between the pressure limits of the 10 mpa and 10 kpa in the boiler and condenser, respectively. due to the metallurgic limits in the fabrication of the turbine blades, the maximum temperature in the cycle is not to exceed 500oc. the isentropic efficiency is 85% for both the turbine and the pump. a)show the cycle on a t-s diagram with respect to saturation lines. b)solve for the rate of work done by the compressor on the steam flow. c)determine the rate of heat input and output in the boiler and condenser, respectively, when the power plant operates at its maximum capacity. d) determine the thermal efficiency of the cycle. e) what is the required mass flow rate of the steam through the cycle to generate 210 mw in the power plant?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0

Answers: 3

Answer

Engineering, 04.07.2019 18:20

What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

You know the right answer?

Asteam power plant operates on a simple nonideal rankine cycle between the pressure limits of the 10...

Questions