subject
Engineering, 21.08.2019 23:30 KevinReed6444

Compressed air is discharged thorough a converging nozzle. the tank pressure is 500kpa, temperature 300k and the local atmospheric pressure is 101kpa. the inlet area of the nozzle is 100cm2; the inlet exit area is 34 cm2. find: (a)the exit gas pressure. (b)the exit gas velocity. (c)the mass flow rate the velocity at the inlet.(d)the pressure at the inlet.(e) assume air acts as ideal gas with y=1.4

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
You know the right answer?
Compressed air is discharged thorough a converging nozzle. the tank pressure is 500kpa, temperature...
Questions
question
Mathematics, 27.05.2020 18:01
Questions on the website: 13722360