Engineering, 21.08.2019 16:20 johnathondevilchil
Brief give the command for exporting your design from cad to the rapid prototyping machine or 3d printer.
Answers: 2
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Brief give the command for exporting your design from cad to the rapid prototyping machine or 3d pri...
Mathematics, 07.01.2021 09:10
English, 07.01.2021 09:10
English, 07.01.2021 09:10
History, 07.01.2021 09:10
English, 07.01.2021 09:10
Social Studies, 07.01.2021 09:10
English, 07.01.2021 09:10
Mathematics, 07.01.2021 09:10
Mathematics, 07.01.2021 09:10
Mathematics, 07.01.2021 09:10
Mathematics, 07.01.2021 09:10
Mathematics, 07.01.2021 09:10
Computers and Technology, 07.01.2021 09:10
English, 07.01.2021 09:10
History, 07.01.2021 09:10
Mathematics, 07.01.2021 09:10