![subject](/tpl/images/cats/User.png)
Engineering, 21.08.2019 05:30 simmy6
A56 mm diameter aluminium tie-rod, 816 mm long, is turned down to a diameter of 32 mm over 237 mm of its length. the rod is then subjected to a 219 kn axial pull. determine the total amount of elongation, x
![ansver](/tpl/images/cats/User.png)
Answers: 2
Another question on Engineering
![question](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
![question](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
![question](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:20
Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options
Answers: 2
![question](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
You know the right answer?
A56 mm diameter aluminium tie-rod, 816 mm long, is turned down to a diameter of 32 mm over 237 mm of...
Questions
![question](/tpl/images/cats/ekonomika.png)
![question](/tpl/images/cats/mat.png)
![question](/tpl/images/cats/mat.png)
![question](/tpl/images/cats/ekonomika.png)
![question](/tpl/images/cats/health.png)
![question](/tpl/images/cats/health.png)
![question](/tpl/images/cats/mat.png)
![question](/tpl/images/cats/mat.png)
![question](/tpl/images/cats/ekonomika.png)
![question](/tpl/images/cats/mat.png)
![question](/tpl/images/cats/mat.png)
Mathematics, 06.03.2020 21:33
![question](/tpl/images/cats/mat.png)
Mathematics, 06.03.2020 21:34
![question](/tpl/images/cats/en.png)
![question](/tpl/images/cats/ap.png)
Advanced Placement (AP), 06.03.2020 21:34
![question](/tpl/images/cats/User.png)
![question](/tpl/images/cats/fizika.png)
![question](/tpl/images/cats/mat.png)
![question](/tpl/images/cats/istoriya.png)
![question](/tpl/images/cats/mat.png)