Engineering, 21.08.2019 00:30 gg808

Asmooth flat plate of length l = 6 m and width b = 4 m is placed in water with an upstream velocity of u = 0.5 m/s. using water properties at 300 k and assuming a laminar boundary layer, determine the boundary layer thickness and the wall shear stress (local value) at the center and at the trailing edge of the plate. determine also the average shear stress and the drag due to friction. was it a good assumption to assume that the boundary layer is laminar?

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

Asmooth flat plate of length l = 6 m and width b = 4 m is placed in water with an upstream velocity...

Questions