Engineering, 20.08.2019 18:30 sierram298

Consider a (9,6) swcnt that is 1000 nm long and answer the following questions. a. what is the diameter of this swcnt? [the nearest distance in the graphene sheet, b=0.142] b. what is its chiral angle? c. is this tube metallic or semiconducting? d. assuming the elastic modulus of 1500 gpa, how much the nanotube will extend if a force of 1nn or 10-9n is applied along the axis of this tube? [elastic modulus= stress/strain, stress= force/cross-section area, strain= change in length/original length] e. estimate the number of defects in a (9,6) carbon nanotube that extends from earth to international space station (iss) that is approximately 200 miles above earth. the energy needed to create a point defect is 1 ev and assume the temperature to be 300 k

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Wiy doeres rere okhn a pump whon working betwon the same pressure range?

Answers: 2

Answer

You know the right answer?

Consider a (9,6) swcnt that is 1000 nm long and answer the following questions. a. what is the diame...

Questions